1. Nozzle maintenance method: when using the nozzle, if it is found that the water spraying is not smooth or blocked, remove the nozzle, unscrew the screw in the middle of the nozzle cover with a screwdriver, remove the assembly cover (remember the position), and clean the debris on the internal surface with a waste toothbrush. After cleaning, install the assembly covers in order, and pay attention to the alignment to prevent affecting the use effect of the nozzle.
2. Maintenance method of tank: to ensure electric fast heating Intelligent thermostatic water heater Safety in use and tank life. If the tank is not used for a long time, the water in the tank can be drained through the safety valve. First close the tap water inlet valve, then pull the mixing valve of the quick heating intelligent thermostatic water heater to the hot water, and then pull the handle of the safety valve upward to the horizontal position, At this time, the water in the tank of the fast heating intelligent thermostatic water heater flows out through the pressure relief port of the safety valve and flows to the sewer through the discharge pipe.
3. The manufacturer of fast heating intelligent thermostatic water heater shall regularly check, clean and maintain it. Domestic gas-fired fast heating intelligent constant temperature water heater is generally cleaned once every 6 to 8 months to reduce emissions of harmful substances and save gas
4. When not in use for a long time, turn off the power supply and drain the water stored in the tank; If the water output of the shower is reduced, the blocked sundries should be cleared in time to ensure the smooth outlet, which is helpful to extend the service life of the fast heating intelligent thermostatic water heater. If the quick heating intelligent constant temperature water heater is not used for a long time, the power plug should be pulled out first to make the quick heating intelligent constant temperature water heater in a power off state.
When taking a bath in winter, the problem of headache is that the water is cold in the middle of the bath, or the water temperature is hot and cold, which can only be finished in a hurry, and it is easy to catch a cold. Therefore, it is particularly important to choose a suitable water heater.
1. For families that don't often use hot water, we recommend that you start to power on the heater one hour before taking a bath, and then turn it off after taking a bath. Normally, you should turn off the water heater. In this way, the electric energy consumption can be kept in a less state, thus saving the electric charge to a large extent.
2. For families that only use the water heater for bathing every day, and the use of hot water is not large, we recommend that the water heater be turned on about an hour before bathing.
3. For frequent use, we recommend that the water heater be kept open all the time. The temperature of hot water can be adjusted according to the frequency of use and the amount of hot water used. If the amount of hot water used is small, the temperature can be lowered a bit, and if the amount of hot water used is large, the temperature can be raised a bit.
4. In case of continuous use (generally referring to commercial users such as hair salons), the water heater can only be kept open, but the temperature of hot water can also be properly adjusted according to the number of guests. So as to save electricity costs to a greater extent.
The fast heating intelligent constant temperature water heater is small in size, fast in heating, stable in water outlet temperature, free from scale formation, and water output is not controlled by capacity. It can continuously produce hot water and save electricity.
Increase the temperature of the water needed immediately, how much to wash, how much to burn, no preheating, no preheating heat loss; Put as much water as you need, and no surplus water will take away a lot of heat. Unlike traditional water storage type Electric water heater The whole barrel of 60 liters or 80 liters of water must be heated before use, resulting in waste of time and energy.
The fast heating intelligent constant temperature water heater controls electricity by water. When the tap of the hot water supply system is turned on, the water heater generates heat instantly. After the faucet is turned off, the water heater will stop operation immediately, and the faucet switch will control the water heater synchronously. The water storage type electric water heater heats and dissipates heat, which is time-consuming and power consuming.
