For cleaning the water heater, a small number of people will choose to pay for professional after-sales masters, while more people are very resistant to this approach, thinking that "it is really not cost-effective to just open the gate to release water, and often hundreds of yuan". In this regard, the editor of Zhongshan Wanmite Electric Appliance Co., Ltd. specially teaches you these three tricks, which can easily remove dirt without spending money!

Integration Intelligent thermostatic water heater The cleaning time is generally 2 to 3 years. Frequent failure to clean will easily lead to electric leakage of scale attached to the heating pipe, and even the possibility of explosion. Cleaning the integrated intelligent thermostatic water heater is something we cannot ignore when using it. Before cleaning the water heater, power and water should be cut off, and then open the cold and hot water pipes of the integrated intelligent thermostatic water heater with a wrench. After removal, the water in the water heater will not come out.

1. One row, two strokes and three tightening

This move is mainly aimed at those with special sewage outlets Electric water heater 。 You need to use a special tool to unscrew the screw cap of the drain outlet at the bottom of the water heater; Then connect the cold water pipe to the hot water outlet and open the cold water angle valve, so that the cold water can be flushed back into the tank through the hot water pipe, so that the dirt can be discharged smoothly - remember to repeatedly flush~~

2. One disassembly, two drainage and three reassembly

This method is also very simple. Remove the joint of the hot water pipe, and the water in the tank will naturally flow out through the pressure relief valve. Wait for a moment, and when there is no water flowing out of the valve, the scale and flocs in the tank will be discharged accordingly. However, this method cannot ensure that the scale in the tank is completely discharged, and a small amount of sewage may remain at the bottom of the tank and cannot be discharged.

3. One check, two check and three power on

This is mainly for users who do not know much about their own water heaters. First, check whether there is dirt residue and leakage at each interface of the water heater. If the interface is found to be dirty than the tank and water pipe, it must be that there is a lot of scale and stagnant water in the tank. If you are unable to complete the above sewage discharge process yourself, it is recommended to seek professional help.

After the scale removal is completed, remember to plug in the power switch and check the heating condition of the water heater. If the water heater can operate normally, it means that the cleaning of the water heater is completed.